Damp, mould and compliance

Damp And Mould Condensation (DCM) Reports

A full damp and mould condensation report for standard, non-emergency cases. We diagnose the underlying cause rather than just the symptom and turn the report around within 48 hours.

The report

What A DCM Report Covers

A DCM report gets to the bottom of damp, mould and condensation in a property. It tells you what is causing the problem, how bad it is and what to do about it.

Standard turnaround is 48 hours. It is the right report for non-emergency cases, where you need a clear diagnosis and a plan rather than the 24 hour emergency response required under Awaab's Law. Every report is produced by competent personnel and written so you can act on it.

What we diagnose

Causes We Diagnose

Damp and mould have several possible causes. A DCM report identifies which you are dealing with.

  • Condensation from ventilation and heating issues
  • Penetrating damp from the building fabric
  • Rising damp at low level
  • Leaks and plumbing faults
  • Cold spots and thermal bridging
  • Resident lifestyle factors where relevant

Which report

DCM Report Or Emergency Report?

If a resident has formally reported damp or mould and the Awaab's Law clock is running, you need the 24 hour emergency report. For everything else, a standard DCM report within 48 hours is the right call.

Awaab's Law emergency reports

Not sure which you need? Tell us the situation and we will point you the right way. The inspection is much the same either way, the difference is the turnaround and how it fits your compliance duties.

Next steps

Remediation You Can Act On

A report is only useful if it tells you what to do. We set out practical remediation options, from ventilation and heating fixes to fabric repairs and a chemical mould wash where it helps.

Chemical mould treatment

You get clear recommendations you can put to a contractor or handle in-house. No vague advice, no filler, just what is wrong and what will fix it. Where a mould wash will help, we can carry that out as a separate service so the problem is dealt with rather than just recorded.

FAQ

Common Questions

How long does a DCM report take?
Standard turnaround is 48 hours from instruction. If the case is an Awaab's Law emergency, ask about our 24 hour report instead.
What is the difference between damp, mould and condensation?
They are linked but not the same. Condensation is the most common cause of household mould, while damp can come from leaks, the ground or the building fabric. A DCM report identifies which you are dealing with.
Do you recommend how to fix it?
Yes. Every report sets out practical remediation options so you can act, whether that is in-house or through a contractor.
Can you treat the mould too?
Yes. Where it helps we can carry out a chemical mould wash, which we cover as a separate service.

Book A DCM Report

Tell us the property and the issue. Standard damp and mould reports within 48 hours, produced by competent surveyors.